Research & Educational Use Only. This protocol guide is for informational purposes only and does not constitute medical advice. Always consult a qualified healthcare professional before beginning any research protocol.
Cartilage / Joint Bioregulator
Weekly Protocol Guide
Cartalax Protocol Guide
Cartalax is a short bioregulatory peptide (Ala-Glu-Asp) studied for cartilage and joint tissue support. It belongs to the Khavinson peptide bioregulator family and is researched for its ability to normalize gene expression in cartilage cells, potentially supporting chondrocyte function and extracellular matrix maintenance.
Protocol Overview
- Compound
- Cartalax (Ala-Glu-Asp Tripeptide Bioregulator)
- Category
- Cartilage / Joint Bioregulator
- Vial Size
- 10mg (10,000mcg)
- Reconstitution
- 2mL bacteriostatic water (5mg/mL)
- Route
- Subcutaneous injection
- Frequency
- Per protocol
Reconstitution Instructions
Using 2mL of bacteriostatic water results in a concentration of 5mg/mL. Typically used in 10-day cycles. Always use sterile techniques.
Materials Needed
- 10mg Cartalax 10mg vial (lyophilized powder)
- 2mL bacteriostatic water (sterile, preserved with 0.9% benzyl alcohol)
- Sterile syringe and needle (18-22 gauge for drawing)
- Alcohol swabs
- Clean workspace
Step-by-Step Process
- Preparation: Allow the Cartalax 10mg vial and bacteriostatic water to reach room temperature. Wipe the rubber stoppers of both vials with an alcohol swab.
- Draw the Water: Using a sterile syringe, draw up exactly 2mL of bacteriostatic water. Expel any air bubbles.
- Inject into Vial: Insert the needle through the rubber stopper at a slight angle, aiming toward the glass wall. Slowly inject the water down the side of the vial to avoid foaming.
- Mix Gently: Remove the needle. Gently swirl or roll the vial between your hands. Do not shake vigorously.
- Check for Clarity: The solution should be clear once fully reconstituted. Do not use if cloudy.
Weekly Dosing Schedule
| Day | Units | Dose | Timing |
|---|
Weekly Total: 28 units (1,400mcg per 7-day cycle) • Vial Duration: ~50 days (5 x 10-day cycles)
Quick Dosing Reference
| Units (Ticks) | Dose (mcg) | Dose (mg) |
|---|---|---|
| 2 | 100 | 0.1mg |
| 4 | 200 | 0.2mg |
| 6 | 300 | 0.3mg |
| 10 | 500 | 0.5mg |
| 20 | 1000 | 1mg |
Administration Guidelines
- Administer subcutaneously once daily during 10-day cycles
- Run 10 days on, then 10-20 days off before repeating
- Rotate injection sites between abdomen, thigh, and upper arm
- Store reconstituted peptide refrigerated at 36-46F (2-8C)
- Use reconstituted solution within 30 days
- Never freeze reconstituted peptides
- Document cycle start/stop dates and observations
Storage Requirements
| State | Storage Conditions |
|---|---|
| Lyophilized (powder) | Room temperature or refrigerated, protect from light |
| Reconstituted | Refrigerated 36-46F (2-8C), use within 30 days |